Mercedes-Benz GLC : Notes on off-road driving / ECO start/stop function
Operation of the ECO start/stop function
The ECO start/stop function is not available
in all drive programs, depending on the
engine. Observe the status display in the
multifunction display for this.
The engine is switched off automatically in the
following situations if all vehicle conditions for
an automatic engine stop are met:
You brake the vehicle to a standstill in transmission
position
or
.
Vehicles with a 48 V on-board electrical
system: You depress the brake pedal when
traveling at a low speed.
If the system has detected one of the following
situations, the engine will not stop:
- You stop at a stop sign and there is no vehicle
in front of you.
- The vehicle that stopped in front of you
starts up again.
- You maneuver, turn the steering wheel
sharply or engage reverse gear.
If the system detects an intelligent stop
inhibitor, for example, a stop sign, the engine
will not stop.
If you activate the HOLD function or engage
the park position
, the engine can
be
switched off in spite of an intelligent stop
inhibitor.
The engine is restarted automatically if:
- You engage transmission position
or
.
- You depress the accelerator pedal.
- An automatic engine start is required by the
vehicle.
- You release the brake pedal.
- Vehicles with a 48 V on-board electrical
system:
- You release the brake pedal on a downhill
gradient and the vehicle does not roll.
- The vehicle rolls on a downhill gradient
and does not automatically enter glide
mode at 15 mph (20 km/h).
ECO start/stop function symbols in the multifunction
display:
- The
symbol (green) appears
when the
vehicle is at a standstill: the engine was
switched off by the ECO start/stop function.
- The
symbol (yellow)
appears when the
vehicle is at a standstill: not all vehicle conditions
for an engine stop have been met.
- Neither the
nor
symbol appears
when the vehicle is at a standstill: an intelligent
stop inhibitor was detected, for example,
a stop sign.
If the engine was switched off by the ECO start/
stop function and you leave the vehicle, a warning
tone sounds and the engine is not restarted.
In addition, the following display message
appears in the multifunction display:
Vehicle Ready to Drive Switch the Ignition Off Before Exiting
If you do not switch off the ignition, it is automatically
switched off after three minutes.
Driving off-road places greater demands on your
vehicle than driving on normal roads. Check the
entire vehicle for damage and foreign bodies
every time after driving off-road...
Press button
.
If indicator lamp lights
up, the ECO start/
stop function is activated.
Depending on the model and the vehicle
equipment, the button may also be located
at a different position in the center console...
Other information:
Climate control can be set centrally using the
synchronization function. The temperature and
air distribution settings for the driver's side will
be adopted automatically for the front passenger
side.
Press the
button.
The synchronization function will be deactivated
if the settings for one of the other climate control
zones are changed...
In this Operator's Manual, you will find the following
symbols:
DANGER
Danger due to not observing the warning notices
Warning notices draw your attention to hazards
that may endanger your health or life, or
the health or life of others.
Observe the warning notices...