Mercedes-Benz GLC : Windshield wiper and windshield washer system / Replacing the windshield wiper blades
WARNING Risk of becoming trapped if
the windshield wipers are switched on
while wiper blades are being replaced
If the windshield wipers begin to move while
you are changing the wiper blades, you can
be trapped by the wiper arm.
Always switch off the
windshield wipers
and the ignition before changing the
wiper blades.
Wipes with washer fluid
Switches on intermittent wiping
Switches off intermittent wiping
Wipes with washer fluid
Turn
switch
to the correct position
-
...
Switch the ignition on and then
off again
immediately.
Within around 15 seconds, press
and hold
the button on the combination
switch for approximately three seconds...
Other information:
Fording depth
NOTE Damage caused by water when
fording
Water can enter the engine compartment
and vehicle interior in the following cases:
The maximum permissible fording depth
when driving through standing water is
exceeded
A bow wave forms during fording
Water accumulates during fording of flowing
water
Do not exceed the maximum
permissible
fording depth and drive slowly
through the water...
Notes on climate control
An interior air filter in combination with the prefilter
in the engine compartment must always be
used so that the air conditioning system, pollution
level monitoring and the air filtration work
correctly. Make sure that the filter is installed
correctly and the filter housing in the engine
compartment is closed correctly using the cap
and always tightly sealed when in operation...