Mercedes-Benz GLC : Replacing the windshield wiper blades / Maintenance display

Remove protective film
from the mainte‐
nance display on the tip of the newly instal‐
led wiper blades.
When the color of the maintenance display
changes from black to yellow, the wiper blades
should be replaced.
The duration until the color changes varies
depending on the usage conditions.
Insert the new wiper blade into
the wiper
arm in the direction of arrow .
Slide catch
in the direction of arrow
until it engages in the locking position...
WARNING Risk of becoming trapped if
the windshield wipers are switched on
while wiper blades are being replaced
If the windshield wipers begin to move while
you are changing the wiper blades, you can
be trapped by the wiper arm...
Other information:
WARNING Risk of entrapment if the
windshield wipers are switched on while
the windshield is being cleaned
If the windshield wipers are set in motion
while you are cleaning the windshield or
wiper blades, you can be trapped by the
wiper arm.
Always switch off the
windshield wipers
and the ignition before cleaning the
windshield or wiper blades...
Cornering light function
The cornering light improves the illumination of
the road over a wide angle in the turning direction,
enabling better visibility on tight curves, for
example. It can be activated only when the low
beam is switched on.
The function is active in the following cases:
At speeds below 25 mph (40 km/h) when
the turn signal light is switched on or the
steering wheel is turned
At speeds between 25 mph (40 km/h) and
43 mph (70 km/h) and when the steering
wheel is turned
Roundabout and intersection function: the
cornering light will be activated on both sides
based on an evaluation of the vehicle's current
GPS position...