Mercedes-Benz GLC : DYNAMIC SELECT switch / Displaying vehicle data. Displaying engine data
Displaying vehicle data
Multimedia system:
Info
Select Vehicle.
The vehicle data is displayed.
Displaying engine data
Multimedia system:
Info
Select Engine.
The engine data is displayed.
The actual (maximum) values that can be
achieved for engine output and engine torque
may deviate from the certified values
within the country-specific guidelines for
permissible tolerances (basis: UN-ECE No.
85 or country-specific guidelines).
Factors that can influence this are, for example:
- Sea level
- Fuel grade
- Outside temperature
- Operating temperature of the engine
The values displayed serve only as orientation.
The values for engine output and
engine torque shown in the media display
may deviate from the actual values.
Multimedia system:
Settings
Vehicle
DYNAMIC SELECT
Setting drive program I
Select Individual
Configuration.
Select and set a category.
Switching the restoration display on or off
Switch Request at
Start on or off...
Other information:
Multimedia system:
Navigation
Where to?
The federal state or province
in which the
vehicle is located
Entering a POI or address
List with additional
destination entry options
Deletes an entry
Confirms an entry
Switches to handwriting
recognition
Enters a space
Switches to voice input
Sets the written language
Switches to digits, special
characters and
symbols
Switches to upper-case or
lower-case letters
Enter the destination in
...
Storing
Set the desired position for
all systems.
Briefly press memory button
and then
press preset position ,
or
within three seconds.
An acoustic signal sounds. The settings are
stored.
To call up: press and hold
preset position
button ,
or
until all the systems
are in the stored position...