Mercedes-Benz GLC : Engine compartment / Checking the engine oil level using the onboard computer
Requirements:
- The engine has been warmed up.
- The vehicle is parked on a level surface.
- The engine is running at idle speed.
- The hood is closed.
The engine oil level is determined during driving.
Determining the engine oil level can take up to
30 minutes with a normal driving style and even
longer with an active driving style.
On-board computer:
Engine Oil Level
One of the following messages will appear on
the multifunction display:
- Measuring Engine Oil Level...: measurement
of the oil level is not yet possible.
Repeat the request after a
maximum of
30 minutes' driving.
- Engine Oil Level OK and the bar display for
indicating the oil level on the multifunction
display is green and is between "min" and
"max": the oil level is correct.
- Engine Oil Level Add 1.0 l and the bar display
for indicating the oil level on the multifunction
display is orange and is below "min":
Add 1.1 US qt (1 l) of engine
oil.
- Reduce Engine Oil Level and the bar display
for indicating the oil level on the multifunction
display is orange and is above "max":
Drain off any excess engine oil
that has been
added. To do so, consult a qualified specialist
workshop.
- For Engine Oil Level Switch Ignition On
Switch on the ignition to check
the engine oil
level.
- Engine Oil Level System Inoperative: The oil
level sensor is malfunctioning or not connected.
Consult a qualified specialist
workshop.
Engine Oil Level System Currently Unavail.
Close the hood.
Checking the engine oil level using the oil dipstick
WARNING Risk of burns from hot component
parts in the engine compartment
Certain component parts in the engine compartment
can be very hot, e...
WARNING Risk of burns from hot component
parts in the engine compartment
Certain component parts in the engine compartment
can be very hot, e.g. the engine,
the cooler and parts of the exhaust system...
Other information:
Requirements:
There are no persons in the vehicle.
The vehicle has been prepared for a wheel
change.
Important notes on using the jack:
Use only a vehicle-specific jack that has
been approved by Mercedes-Benz to raise
the vehicle.
The jack is only designed for raising and
holding the vehicle for a short time while a
wheel is being changed and not for maintenance
work under the vehicle...
Requirements:
The vehicle is secured with the electric parking
brake.
Vehicles with automatic transmission:
The transmission is in position .
The ignition and all electrical consumers are
switched off.
The hood is open.
Example: engine compartment
Slide cover
of positive clamp
on the
jump-starting connection point in the direction
of the arrow...