Mercedes-Benz GLC : Data storage / Data protection rights
Depending on your country or the equipment
and range of functions of your vehicle as well as
the services you use and the services on offer,
you are entitled to different data protection
rights. Further information on data protection
and your data protection rights can either be
found on the manufacturer's website or you will
receive this information as part of the various
services and service offers. There you will also
find the contact information for the manufacturer
and its data protection officers.
At a workshop, for example, with the support of
a specialist and possibly for a fee, you can have
data read out which is stored only locally in the
vehicle.
If you use online services from other providers
(third parties), these services are the responsibility
of the provider in question and subject to
that provider's data protection conditions and
terms of use...
If the vehicle is equipped with the MBUX multimedia
system or Mercedes me connect, additional
data about the vehicle's operation, the use
of the vehicle in certain situations, and the location
of the vehicle may be compiled by the MBUX multimedia system or Mercedes me
connect...
Other information:
Cornering light function
The cornering light improves the illumination of
the road over a wide angle in the turning direction,
enabling better visibility on tight curves, for
example. It can be activated only when the low
beam is switched on.
The function is active in the following cases:
At speeds below 25 mph (40 km/h) when
the turn signal light is switched on or the
steering wheel is turned
At speeds between 25 mph (40 km/h) and
43 mph (70 km/h) and when the steering
wheel is turned
Roundabout and intersection function: the
cornering light will be activated on both sides
based on an evaluation of the vehicle's current
GPS position...
WARNING Risk of becoming trapped if
the windshield wipers are switched on
while wiper blades are being replaced
If the windshield wipers begin to move while
you are changing the wiper blades, you can
be trapped by the wiper arm.
Always switch off the
windshield wipers
and the ignition before changing the
wiper blades...